LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Outback 2.5i Limited >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Auto Headlight Leveler Beam System (Diagnostics) >> Control Module I/O Signal >> Electrical Specification >> Auto Headlight Beam Leveler Control Module
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Auto Headlight Beam Leveler Control Module

G08549445Courtesy of SUBARU OF AMERICA, INC.
Terminal No. Contents Measuring condition Standard
1 ←→ Chassis ground IG power supply Ignition switch ON 8 - 16 V
2 ←→ Chassis ground GND Always Less than 1 Ω
3 ←→ Chassis ground Rr vehicle height sensor GND Always Less than 1 Ω
4 - - -
5 ←→ Chassis ground RH headlight malfunction signal Always 1 MΩ or more
6 - - -
7 ←→ Chassis ground SRH signal (LIN) Always 1 MΩ or more
8 - - -
9 ←→ Chassis ground SRH GND Always Less than 1 Ω
10 ←→ Chassis ground Leveling actuator power supply Ignition switch ON 10 - 16 V
11 ←→ Chassis ground Leveling actuator GND Always Less than 1 Ω
12 ←→ 3 Rr vehicle height sensor power supply Ignition switch ON 4.75 - 5.25 V
13 - - -
14 - - -
15 - - -
16 ←→ Chassis ground LH headlight malfunction signal Always 1 MΩ or more
17 ←→ Chassis ground Leveling actuator signal Headlight off → on Less than 1 V → 1.0 - 14.4 V (for 17 seconds)
Headlight on, no vehicle height change → change and hold vehicle height for 3 seconds or more
18 - - -
19 ←→ Chassis ground Rr sensor signal IG ON (with no passenger, no load and vehicle stopped) Approx. 2.5 V (changes according to vehicle condition)
20 - - -
21 - - -
22 - - -
23 CAN-H Cannot be measured (CAN communication line) -
24 CAN-L Cannot be measured (CAN communication line) -
scientia non olet · About LEMON Manuals