LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2018 >> Impreza Base, 4D Sedan, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System (Diagnostics - Introduction)) >> Inspection Mode >> Procedure >> SUBARU Select Monitor
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

SUBARU Select Monitor

WARNING: This page is about a different car, the 2018 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clear the memory. Ref. to COMMON (diag)>CLEAR MEMORY .
  2. Read the diagnostic trouble code (DTC) and check that no DTC is displayed. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>DATA MONITOR .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . After solving the DTC, repeat from step  1.
  3. Start the engine, and run the engine at idle for 10 seconds or more.
  4. Read the diagnostic trouble code (DTC) and check the DTC. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>DATA MONITOR .
NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . After solving the DTC, repeat from step  1.
scientia non olet · About LEMON Manuals