October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Select Lever: Removal
- Shift the select lever to "N" range.
- Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY
.
- Lower the boot assembly vertically toward the lever. (Model with boot shifter)
 Courtesy of SUBARU OF AMERICA, INC.
|
- Lower the cover grip AT vertically toward the lever. (Model with gate shifter)
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the clamp grip pin.
- Model with boot shifter
 Courtesy of SUBARU OF AMERICA, INC.
|
- Model with gate shifter
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the grip assembly.
- Model with boot shifter
 Courtesy of SUBARU OF AMERICA, INC.
|
- Model with gate shifter
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the front console panel. Ref. to EXTERIOR/INTERIOR TRIM>Console Box>REMOVAL
.
- Remove the panel center LWR LH and RH. Ref. to EXTERIOR/INTERIOR TRIM>Console Box>REMOVAL
.
- Remove the harness clip from the select lever assembly.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Separate the floor carpet to three layers, and cut them while staggering their cut position as shown in the figure.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Disconnect the harness connector.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove four bolts.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Lift up the vehicle.
- Remove the center exhaust cover.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the snap pin and washer from the shifter arm.
CAUTION:
Do not apply excessive load while holding the part (a).
 Courtesy of SUBARU OF AMERICA, INC.
|
 Courtesy of SUBARU OF AMERICA, INC.
|
- Remove the plate assembly from the transmission case.
 Courtesy of SUBARU OF AMERICA, INC.
|
- Lower the vehicle, and remove the select lever assembly from the room side.
NOTE:
Pass the select cable from the underside of the vehicle to the room side.