Inspection Mode 3
| DTC | Item | Note |
|---|---|---|
| B1570 | ANTENNA | - |
| B1571 | REFERENCE CODE INCOMPATIBILITY (IMMOBILIZER CONTROL MODULE TO ECM) | - |
| B1572 | IMM CIRCUIT EXCEPT ANTENNA CIRCUIT | - |
| B1574 | KEY COMMUNICATION | - |
| B1575 | INCORRECT IMMOBILIZER KEY | - |
| B1576 | EGI CONTROL MODULE EEPROM | - |
| B1577 | IMM CONTROL MODULE EEPROM | - |
| B1578 | METER | - |
Diagnostic procedure:
- Perform the Clear Memory Mode. Ref. to CLEAR MEMORY MODE
- Read the DTC and check that the DTC is not displayed. Ref. to
READ DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1
- Start the engine, and then run the engine at idle for 10 seconds or more. Or, disconnect and reconnect the battery, then turn the ignition switch OFF → ON, and wait for 10 seconds or more.
- Read the DTC and check that the DTC is not displayed. Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC)
NOTE:
If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.