LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (WRX) >> Throttle Body >> Inspection >> Throttle Sensor (Method With Circuit Tester)
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Throttle Sensor (Method With Circuit Tester)

  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Note. >
  2. Remove the engine control module (ECM). < Ref. to REMOVAL , Engine Control Module (ECM). >
  3. Install the ST between the ECM and bulkhead harness and the engine harness. < Ref. to CAUTION , General Descriptions

    ST 18460AA030 CHECK BOARD

  4. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Note. >
  5. After warming-up the engine, turn the ignition switch to OFF.
  6. Turn the ignition switch to ON. (engine OFF)
  7. Measure the voltage between ECM connector terminals using ST.
    Fig 1: Measuring Voltage Between ECM Connector Terminals Using Check Board ST18460AA030
    G10291108Courtesy of SUBARU OF AMERICA, INC.
    Throttle sensor Accelerator pedal Terminal No. Standard
    Main Not depressed (full closed) 17 (+) and 30 (-) Approx. 0.7 V
    Depressed (full opened) Approx. 3.9 V
    Sub Not depressed (full closed) 29 (+) and 30 (-) Approx. 4.4 V
    Depressed (full opened) Approx. 1.1V
  8. After inspection, install the related parts in the reverse order of removal.
scientia non olet · About LEMON Manuals