LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (WRX) >> Knock Sensor >> Installation >> RH Side
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

RH Side

  1. Install the knock sensor to the cylinder block.
    NOTE: The knock sensor should be installed so that the center of the connector is positioned at a 32.5 - 47.5° angle relative to the rear of engine.

    Tightening torque: 

    24 N.m (2.4 kgf-m, 17.7 ft-lb) 

    Fig 1: Identifying Knock Sensor Connector Tightening Angle (RH Side)
    G10291259Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector to the knock sensor.
    Fig 2: Locating Knock Sensor Connector (RH Side)
    G09479755Courtesy of SUBARU OF AMERICA, INC.
  3. Install the fuel pipe insulator No. 3. < Ref. to FUEL PIPE INSULATOR NO. 3 , INSTALLATION, Fuel Insulator. >
  4. Install the intake manifold. < Ref. to INSTALLATION , Intake Manifold. >
  5. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Note. >
  6. Install the collector cover. < Ref. to INSTALLATION , Collector Cover. >
scientia non olet · About LEMON Manuals