LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> BRZ Limited, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnostics - System & Circuit Checks >> MIL Circuit >> Inspection steps
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection steps

  1. MIL illumination check
    1. Check the illumination status of MIL.

      Result

      MIL Inspection conditions Go to
      Always lit. IG ON →After engine start A
      Always unlit. IG ON →After engine start B
      ON →OFF IG ON →After engine start C

      B: Go to Step  3.

      C: Inspection for problems that do not normally occur (refer to PROCEDURES FOR MALFUNCTION PHENOMENON SIMULATION )

      A: Go to next step

  2. Read DTC
    1. Connect the SSM3 to the DLC3.
    2. Turn the ignition switch to ON.
    3. Follow the SSM3 on-screen instructions to check the DTC. (Refer to CHECKING/CLEARING DTC )

      Result

      Result Go to
      No DTC is output A
      DTC is output. B

      B: To corresponding DTC chart (refer to DTC TABLE )

      A: Go to meter & gauge system (refer to HOW TO TROUBLESHOOT )

  3. Engine starting inspection
    1. Check that the engine starts.

      Criteria: The engine starts.

      NG: Go to VC POWER SUPPLY CIRCUIT INSPECTION  (Refer to )

      OK: Replace combination meter assembly (refer to COMBINATION METER ASSEMBLY )

scientia non olet · About LEMON Manuals