Section 82 (Starting System & Charging System (H4DO)): Generator: Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Temporarily install the generator bracket to the engine and tighten the bolts in the numerical order.
Tightening torque:

36 N.m (3.7 kgf-m, 26.6 ft-lb)

Fig 1: Engine Generator Bracket Bolts Tightening Sequence
Courtesy of SUBARU OF AMERICA, INC.
Install the V-belt tensioner. <Ref. to V-BELT TENSIONER ASSEMBLY , INSTALLATION, V-belt.>
Temporarily install the generator bracket to the generator and tighten the bolts in the numerical order.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 2: Engine Generator Bracket Bolts Tightening Sequence
Courtesy of SUBARU OF AMERICA, INC.
Install the V-belt cover bracket.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 3: Locating V-Belt Cover Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector (A) and terminal (B) to the generator, and attach the clip (C).
Tightening torque:

15 N.m (1.5 kgf-m, 11.1 ft-lb)

Fig 4: Identifying Generator Connector And Terminal
Courtesy of SUBARU OF AMERICA, INC.
Install the V-belts. <Ref. to INSTALLATION , V-belt.>
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>