LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Power Rear Gate (Service Information)) >> Power Rear Gate Rod >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Power Rear Gate Rod: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback, 2016 Subaru Legacy, 2015 Subaru Outback, and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new stop ring to the rod - power rear gate.
    CAUTION:
    • Do not reuse the stop ring.
    • Align the stop ring to the ball housing groove, and attach the ring by gradually applying force, while paying attention not to deform it.
  2. Check the clearance (a) of the stop ring.
    Fig 1: Checking Power Rear Gate Stop Ring Clearance
    G09485098Courtesy of SUBARU OF AMERICA, INC.

    Specification: 

    6.4 - 7.2 mm (0.25 - 0.28 in) 

    Replace the stop ring if the inspection result is not within the standard value.

  3. Install the rod - power rear gate.
    CAUTION:
    • Do not install the battery sensor ground terminal before installing the rod. If the power rear gate drive unit moves by wrong operation of the switch, the installation of the rod may be no longer possible.
    • Check that the stop ring and ball stud are vertically placed, and then slowly press in the rod.
    • Install the rod with its angular end facing downward.
    Fig 2: Identifying Power Rear Gate Rod
    G10309978Courtesy of SUBARU OF AMERICA, INC.
  4. Install the cap - rear quarter pillar UPR LH.
  5. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals