LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Fuel Injection System (H4DO)) >> Oil Control Solenoid >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Oil Control Solenoid: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intake oil control solenoid to the chain cover, and connect the connector to the intake oil control solenoid.
    NOTE:
    • Use new O-rings.
    • Apply engine oil to O-ring.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

  2. Install the air intake duct. (RH side only) < Ref. to INSTALLATION , Air Intake Duct. >
  3. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals