LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Engine Lubrication System (H6DO)) >> Oil Level Switch >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Oil Level Switch: Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the oil level switch harness as shown in the figure.
    Fig 1: Identifying Oil Level Switch Harness
    G10264251Courtesy of SUBARU OF AMERICA, INC.
  2. Attach the oil level switch to the oil pan upper.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

  3. Connect the connector of the oil level switch to the engine harness, and install the clips securing the harness to the front camshaft cap (LH) and the cylinder head (LH).
  4. Install the under cover. <Ref. to INSTALLATION , Front Under Cover.>
  5. Lower the vehicle.
  6. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
  7. Refill the engine oil. <Ref. to REPLACEMENT , Engine Oil.>
scientia non olet · About LEMON Manuals