LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Cooling System (H6DO)) >> Water Pump >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Water Pump: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Tighten the bolts in the numerical order as shown in the figure, and install water pump to the oil pan upper.
    NOTE: Use new O-rings.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 1: Locating Water Pump To Oil Pan Upper Mounting Bolts
    G05667980Courtesy of SUBARU OF AMERICA, INC.
  2. Install the timing chain assembly. Refer to INSTALLATION .
  3. Install the chain cover. Refer to INSTALLATION .
  4. Install the crank pulley. Refer to INSTALLATION .
  5. Install the V-belts. Refer to INSTALLATION .
  6. Install the radiator. Refer to INSTALLATION .
  7. Fill engine coolant. Refer to FILLING OF ENGINE COOLANT .
scientia non olet · About LEMON Manuals