LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Fuel Injection Fuel Systems (H4DOTC)) >> Knock Sensor >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Knock Sensor: Installation

WARNING: This page is about a different car, the 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knock sensor to the cylinder block.
    NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

    Tightening torque: 

    24 N.m (2.4 kgf-m, 17.7 ft-lb) 

    Fig 1: Locating Knock Sensor Mounting Bolt
    G07910758Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector to the knock sensor.
    Fig 2: Locating Knock Sensor Connector
    G06648849Courtesy of SUBARU OF AMERICA, INC.
  3. Install the intercooler. Refer to INTERCOOLER .
  4. Connect the ground cable to battery.
    Fig 3: Connecting Ground Cable To Battery
    G07910760Courtesy of SUBARU OF AMERICA, INC.
  5. Install the collector cover.
scientia non olet · About LEMON Manuals