LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Anti-Theft System - Immobilizer (Diagnostics)) >> Subaru Select Monitor >> Operation >> Communication Line Check
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Communication Line Check

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The communication line between ECM and body integrated unit can be checked in "System Operation Check Mode". This is referred to as "Communication line check".
  1. Connect the Subaru Select Monitor.
  2. On the «Main Menu» display, select {Each System Check}.
  3. On the «System Selection Menu», select {Engine Control System}.
  4. After engine type information is displayed, select [OK].
  5. On the «Engine Diagnosis» display, select {System Operation Check Mode}.
  6. On the «System Operation Check Mode» display, select the {Immobilizer System}.
  7. Start the communication line check.
  8. Is «OK» displayed on screen?

    If displayed, go to step 9.

    If not, go to step  10).

  9. After diagnostic results, it is determined that the circuit is not shorted. Finish the communication line check.
  10. If a problem is detected, repair the trouble cause. Ref. to DTC P1572 IMM CIRCUIT FAILURE (EXCEPT ANTENNA CIRCUIT) , Diagnostic Procedure with Diagnostic Trouble Code (DTC).
scientia non olet · About LEMON Manuals