Rear Shock Absorber: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be sure to use a new self-locking nut.
Always tighten bushings with wheels in full contact with the ground and the vehicle at curb weight.

Install in the reverse order of removal.
CAUTION: Attach so that the protrusion on the top of the mount is pointed towards the front of the vehicle.

Fig 1: Identifying Protrusion Portion And Mount
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Refer to "COMPONENT" of "General Description" for the tightening torque. Refer to COMPONENT , General Description.
Check the wheel alignment and adjust it if necessary.