LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Legacy R >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection Fuel Systems (H6DO) >> Crankshaft Position Sensor >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Crankshaft Position Sensor: Removal

  1. Remove the collector cover.
    NOTE: Follow the steps below when removing the collector cover.
    1. Pull up the two points at the rear (A).
    2. Pull up the two points at the front (B) while moving them forward.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Remove the air intake boot assembly. Refer to AIR INTAKE BOOT .
  4. Remove the throttle body from the intake manifold.
    NOTE: Do not disconnect the inlet and outlet hoses of engine coolant.
  5. Remove the service hole plug.
    Fig 2: Locating Service Hole Plug
    G06649725Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the crankshaft position sensor.
    Fig 3: Locating Crankshaft Position Sensor Bolt
    G07912300Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector from crankshaft position sensor.
scientia non olet · About LEMON Manuals