LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2011 >> Outback i, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Instrumentation/Driver Info) >> Combination Meter System >> Inspection >> Check ECO Gauge
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Check ECO Gauge

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Step Check Yes No
1 CHECK DIAGNOSTIC TROUBLE CODE (DTC). 
  1. Prepare the Subaru Select Monitor kit.
  2. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  3. On << System Selection Menu >> display, select {Integ. unit mode}.
  4. Select the {Diagnostic Code(s) Display}.
 Is a DTC of high-speed CAN detected? Perform the diagnosis according to DTC. Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . Go to step 2. 
2 CHECK ECO GAUGE. 
Perform the self-diagnosis of combination meter. Refer to , SELF-DIAGNOSIS DISPLAY MODE , OPERATION, Combination Meter System.		 Does ECO gauge operate properly? Check the connection status of the harness and connector that may have a temporary poor contact. Replace the meter case assembly. Refer to , COMBINATION METER .
scientia non olet · About LEMON Manuals