Direct Clutch Assembly

• Check the clearance of direct clutch.

  Measure the clearance "L" between snap ring and retaining plate using a thickness gauge. If it is out of specification, replace the entire direct clutch assembly.

• Check for damage on the drive plate, driven plate and snap ring, and replace the entire direct clutch assembly if damaged.

Standard: 

0.6 - 1.0 mm (0.024 - 0.039 in) 

Fig 1: Measuring Clearance Between Snap Ring And Retaining Plate Of Direct Clutch Assembly Using Thickness Gauge

Courtesy of SUBARU OF AMERICA, INC.