Section 85 (Cooling System (H6DO)): Radiator: Installation
WARNING: This page is about a different car, the 2007 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
- Attach the radiator lower cushions to holes on the vehicle.
- Install the radiator to vehicle.NOTE: Make pins on the lower side of radiator be fitted into the radiator lower cushions on body side.
- Install the radiator upper brackets and tighten the bolts.
Tightening torque:
12 N.m (1.2 kgf-m, 8.9 ft-lb)
- Connect the radiator inlet hose.
- Install the reservoir tank. <Ref. to INSTALLATION , Reservoir Tank .>
- Connect the connector to the radiator fan control unit.
- Install the air intake duct. <Ref. to INSTALLATION , Air Intake Duct.>
- Install the hood stay holder.
- Lift up the vehicle.
- Connect the ATF cooler hoses.
- Connect the radiator outlet hose.
- Install the under cover.
- Lower the vehicle.
- Connect the battery ground cable to battery.
- Fill engine coolant. <Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant .>
- Check the ATF level. <Ref. to INSPECTION , Automatic Transmission Fluid.>
- Install the collector cover.