Data Display
WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
- On the «Main Menu», select {Each System Check}.
- On the «System Selection Menu», select {Tire Pressure Monitor}.
- After the {Tire Pressure Monitor} is displayed, select [OK].
- On the «Tire Pressure Monitor Diagnosis», select the {Data Display}, and then necessary data will be displayed.
- A list of the support data is shown in the following table.
- Data monitor Analog) SUPPORT DATA LIST - DATA MONITOR ANALOG)
Display Contents to be monitored Unit of measure FR FN Code LEARN, LOW BAT, OFF, WAKE, RE ME, NORMAL LEARN: Transmitted transmitter ID using the transmitter registration tool
LOW BAT: Transmitter battery voltage running low
OFF: Transmitter function stops (no data transmission)
RE ME: Tire air changes ± 8.4 kPa
WAKE: When data transmission is started from a stopped state.
NORMAL: Conditions other than aboveFL FN Code RR FN Code RL FN Code FR tire pressure Value converted to tire pressure from data delivered from transmitter is displayed.
(The figure may differ from the actual measured values.)kPa, psig, mmHg, inHg FL tire pressure kPa, psig, mmHg, inHg RR tire pressure kPa, psig, mmHg, inHg RL tire pressure kPa, psig, mmHg, inHg Vehicle Speed Vehicle speed signal which is input in control module. km/h, MPH Pressure warning Threshold where tire pressure warning light illuminates kPa, psig, mmHg, inHg Return pressure Threshold where tire pressure warning light goes out kPa, psig, mmHg, inHg