LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Starting System & Charging System (H4SO) >> Battery >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Starting System & Charging System (H4SO): Battery: Installation

Install in the reverse order of removal.

Tightening torque: 

3.4 N.m (0.35 kgf-m, 2.5 ft-lb) 

NOTE:
  • Clean the battery cable terminals and apply grease to retard the formation of corrosion.
  • Connect the battery positive (+) terminal, and then connect the negative (-) terminal.
  • After the battery is installed, initial diagnosis of the electronic throttle control is performed. For this reason, start the engine 10 seconds or more after the ignition switch was turned to ON.