Read Current Data For Engine (OBD Mode)
WARNING: This page is about a different variant/trim than selected.
- On the «Main Menu» display screen, select {Each System Check}.
- On the «System Selection Menu» display screen, select {Engine Control System}.
- Select the [OK] after the information of engine type has been displayed.
- On the «Engine Diagnosis» display screen, select the {OBD System}.
- On the «OBD Menu» display screen, select the {Current Data Display/Save}.
- On the «Data Display Menu» screen, select {Data Display}.
- Using the scroll key, scroll the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.SUPPORT DATA CHART
Contents Display Unit of measure Note (at idling) Number of diagnosis code Number of Diag. Code: - - Condition of malfunction indicator light Ml (MIL) - ON or OFF Monitoring test of misfire Misfire Monitoring - Finish or incomplete Monitoring test of fuel system Fuel system monitoring - Finish or incomplete Monitoring test of comprehensive component Component monitoring - Finish or incomplete Test of catalyst Catalyst Diagnosis - Finish or incomplete Test of heating-type catalyst Heated catalyst - No support Test of evaporative emission purge control system Evaporative purge system - Finish or incomplete Test of secondary air system Secondary air system - Finish or incomplete Test of air conditioning system refrigerant A/C system refrigerant - No support Test of oxygen sensor Oxygen sensor - Finish or incomplete Test of oxygen sensor heater 02 Heater Diagnosis - Finish or incomplete Test of EGR system EGR system - No support Air fuel ratio control system for bank 1 Fuel System for Bank 1 - Normal CLOSE Engine load data Calculated load value % 1.6% Engine coolant temperature signal Coolant Temp. °C or °F +91°C or 196°F Short term fuel trim by front oxygen (A/F) sensor Short term fuel trim B1 % +0.0 % Long term fuel trim by front oxygen (A/F) sensor Long term fuel trim B1 % +1.6 % Intake manifold absolute pressure signal Mani. Absolute Pressure mmHg, kPa, inHg or psig 256 mmHg Engine speed signal Engine Speed rpm 693 rpm Vehicle speed signal Vehicle Speed km/h or MPH 0km/h #1 Cylinder ignition timing Ignition timing adv. #1 ° +16.0° Intake air temperature signal Intake Air Temp. °C or °F 54°C or 129°F Amount of intake air Mass Air Flow g/s or lb/m 3.1 g/s Throttle position signal Throttle Opening Angle % 13% Oxygen sensor #12 Oxygen Sensor#12 V + 0.800 V Air fuel ratio correction by rear oxygen sensor Short term fuel trim #12 % +0.8% On-board diagnostic system OBD System - CARB-OBD2 Oxygen sensor #11 Oxygen Sensor #11 - Support Rear oxygen sensor output signal Oxygen Sensor #12 - Support A/F lambda signal A/F sensor #11 - 0.984 A/F sensor output signal A/F sensor #11 V 2.712 V A/F lambda signal #11 A/F sensor #11 - 0.992 A/F sensor current #11 A/F sensor #11 mA -0.03 mA Secondary air control status Secondary air system - - Time elapsed after engine start Elapsed Time After Starting Engine sec - Elapsed time after MIL illuminating Elapsed Time After MIL Illuminates km or miles - Evaporative purge Evaporative purge % - Fuel level Fuel level % - Number of warm ups after DTC clear Number Of Warm Ups After DTC Clear - - Travel distance after DTC clear Travel distance after DTC clear km or miles - Fuel tank pressure Fuel Tank Pressure mmHg, kPa, inHg or psig - Atmospheric pressure Atmospheric Pressure mmHg, kPa, inHg or psig - Catalyst temperature #1 Catalyzer temperature #1 °C or °F - Misfire monitoring Misfire Monitoring Enable YES or NO Comp YES or NO Fuel system diagnosis Fuel system monitoring Enable YES or NO Comp YES or NO Component monitoring Component monitoring Enable YES or NO Comp YES or NO Catalyst diagnosis Catalyst Diagnosis Enable YES or NO Comp YES or NO Heated catalyst diagnosis Heated catalyst Enable N/A Comp N/A Evaporative purge system diagnosis Evaporative purge system Enable YES or NO Comp YES or NO Secondary air system Secondary air system Enable YES or NO Comp YES or NO A/C system refrigerant diagnosis A/C system refrigerant Enable N/A Comp N/A Oxygen sensor diagnosis Oxygen sensor Enable YES or NO Comp YES or NO Oxygen heater diagnosis 02 Heater Diagnosis Enable YES or NO Comp YES or NO EGR diagnosis EGR system Enable N/A Comp N/A ECM power voltage ECM power voltage V - Absolute load Absolute load % - A/F target lambda A/F target lambda - - Relative throttle opening angle Relative throttle position % - Ambient temperature Ambient temperature °C or °F - Absolute throttle opening angle 2 Absolute throttle opening angle 2 % - Absolute accelerator opening angle 1 Absolute accelerator opening angle 1 % - Absolute accelerator opening angle 2 Absolute accelerator opening angle 2 % - Target throttle opening angle Target throttle opening angle % - Engine operation time during MIL on Engine operating time during MIL illuminates min - Elapsed time after DTC clear Elapsed time after DTC clear min - Fuel used Fuel used - - Relative accelerator opening angle Relative accelerator opening angle % - NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".