6MT Model

Remove the spring pin from the slider.

Fig 1: Identifying Spring Pin And Slider
Courtesy of SUBARU OF AMERICA, INC.
Remove the slider and spring.

Fig 2: Identifying Slider And Spring
Courtesy of SUBARU OF AMERICA, INC.
Cut the band clip.
Remove the reverse check cable from the cable plate.

Fig 3: Identifying Reverse Check Cable And Cable Plate
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse check cable from the gear shift assembly.

Fig 4: Identifying Reverse Check Cable
Courtesy of SUBARU OF AMERICA, INC.
Remove the holder and spring.

Fig 5: Identifying Holder And Spring
Courtesy of SUBARU OF AMERICA, INC.
Disassemble the lock wires.
NOTE: Do not reuse the lock wire.

Fig 6: Identifying Lock Wires
Courtesy of SUBARU OF AMERICA, INC.
Remove the boss from the rod.

Fig 7: Identifying Boss And Rod
Courtesy of SUBARU OF AMERICA, INC.
Remove the rod from lever.

Fig 8: Identifying Rod And Lever
Courtesy of SUBARU OF AMERICA, INC.
Separate the rod and inner boot.
Remove the snap ring from the stay.

Fig 9: Identifying Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Separate the gear shift lever and the stay.

Fig 10: Identifying Gear Shift Lever And Stay
Courtesy of SUBARU OF AMERICA, INC.
Remove the boot and bushing from gear shift lever.

Fig 11: Identifying O-Ring And Bushing
Courtesy of SUBARU OF AMERICA, INC.
Remove the spring pin, and then remove the bushing and snap ring.

Fig 12: Identifying Bushing And Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the bushing and spacer from the boss. 2) Install the bushing and spacer to boss.

Fig 13: Identifying Bushing And Spacer
Courtesy of SUBARU OF AMERICA, INC.
Remove the bushing and cushion rubber from the stay.

Fig 14: Identifying Bushing And Cushion Rubber
Courtesy of SUBARU OF AMERICA, INC.