LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> Outback i, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (H6DO)) >> Oil Pressure System >> Inspection
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Oil Pressure System: Inspection

WARNING: This page is about a different variant/trim than selected.
DIAGNOSIS PROCEDURE

Step Check Yes No
1 CHECK COMBINATION METER. 
  1. Turn the ignition switch to ON. (engine OFF)
  2. Check the warning light of combination meter.
 Does the warning light illuminate? Go to step 2  . Repair or replace the combination meter. <Ref. to INSPECTION .>
2 CHECK HARNESS CONNECTOR BETWEEN COMBINATION METER AND OIL PRESSURE SWITCH. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector from oil pressure switch.
  3. Turn the ignition switch to ON.
  4. Measure the voltage between the oil pressure switch connector and the engine ground.

    Connector & terminal 

    (E11) No. 1 (+) - Engine ground (-): 

 Is the voltage 10 V or more? Replace the oil pressure switch. <Ref. to OIL PRESSURE SWITCH . > Go to step 3  .
3 CHECK COMBINATION METER. 
  1. Turn the ignition switch to OFF.
  2. Remove the combination meter.
  3. Measure the resistance of combination meter.

    Terminals 

    (HO) No. 3 - (HO) No. 15: 

 Is the resistance less than 10 Ω? Repair the harness and connector.
NOTE: In this case, repair the following item:
  • Open circuit of harness between combination meter and oil pressure switch
  • Poor contact in combination meter connector
  • Poor contact in oil pressure switch connector
  • Poor contact of coupling connector
 Repair or replace the combination meter. <Ref. to INSPECTION .>
scientia non olet · About LEMON Manuals