Check ABSCM Or VDCCM

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSIS PROCEDURE

Step	Check	Yes	No
1 CHECK VEHICLE SPEED SIGNAL. Lift up the vehicle and support it with rigid racks. Drive the vehicle faster than 10 km/h (6 MPH). WARNING: Be careful not to get caught in the running wheels. Measure the voltage between combination meter connector and chassis ground. Connector & terminal (110) No. 19 (+) - Chassis ground (-):	Is the voltage less than 1 V ↔ 5 V or more?	Replace the meter case assembly.	Go to step 2 .
2 CHECK HARNESS BETWEEN ABSCM OR VDCCM AND COMBINATION METER. Turn the ignition switch to OFF. Disconnect the connector from ABSCM or VDCCM and combination meter. Measure the resistance between ABSCM or VDCCM harness connectors and the combination meter harness connector. Connector & terminal Model without VDC (B301) No. 23 - (i10) No. 19: Model with VDC (B310) No. 36 - (i10) No. 19:	Is the resistance less than 10Ω	Model without VDC: Check the ABSCM. < Ref. to BASIC DIAGNOSTIC PROCEDURE . > Model with VDC: CHECK THE VDCCM. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >	Repair the wiring harness.