Registration Of Keyless Transmitter With SUBARU Select Monitor
NOTE:
- A maximum of four keyless transmitter can be registered for each individual vehicle.
- When replacing or adding the keyless transmitter, new registration of transmitter is necessary.
- Connect the Subaru Select Monitor to the vehicle.
- Turn the ignition switch to ON.
- From the «Main menu» of the Subaru Select Monitor, select {2. Check individual system} → {Keyless unit mode} →{1. Transmitter ID registration}.
- Input the 8-digit ID number attached to the plastic bag of the keyless transmitter or on the circuit board inside the transmitter, from left to right, then press the [Enter] key.NOTE: Press the [↑ ] key on the Subaru Select Monitor to increase the number, and the [↓ ] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.
- The ID number you have entered will be shown. Make sure that the ID number shown is the same as that on the plastic bag.
- If the ID number matches, select [OK]. If the ID number is incorrect, select [NO] to return to the step 3) and reenter the ID number.
- «ID registration in process...» is displayed and registration starts.
- «ID registration done» will be displayed when the registration process is done.
- To exit, select «END: NO», to return to {1. Keyless transmitter ID registration}. If there are additional keyless transmitters to be registered, select «Next registration: OK» to return to the step 3).
NOTE:
- If the registration fails, «ID registration failed. Try again.» will be displayed. Select the [OK] to return to the {1. Transmitter ID registration}. And retry from the step 2).
- «END: NO» will be shown on the Subaru Select Monitor when the fourth keyless transmitter has been registered. Select the [NO] key to return to {1. Keyless transmitter ID registration}.