LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Diagnostics) (H6DO) >> Subaru Select Monitor >> Operation >> Led Operation Mode For Engine
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Led Operation Mode For Engine

  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Engine Control System}.
  3. Select the [OK] after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}.
  5. On the «Data Display» screen, select the {Data LED Display}.
  6. Using the scroll key, scroll the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
      SUPPORT DATA

      Description Display Message When LED "ON" required
      Test mode signal Test mode terminal D check/U check D check
      Neutral position switch signal Neutral SW Neutral/Other than neutral Neutral
      Idle switch signal Soft idle SW Idle/Other than idle In idle
      Ignition switch signal Ignition SW ON Input/OFF Input ON input
      Power steering switch signal Power steering SW ON Input/OFF Input ON input
      Air conditioning switch signal A/C SW ON Input/OFF Input ON input
      Starter switch signal Starter SW ON Input/OFF Input ON input
      Front oxygen monitor 1 FtO2 monitor 1 Lean/Rich Rich
      Front oxygen monitor 2 FtO2 monitor 2 Lean/Rich Rich
      Knocking signal Knock signal Yes/No Yes
      Crankshaft position sensor signal Crankshaft angle signal Yes/No Yes
      Camshaft position sensor signal Camshaft angle signal Yes/No Yes
      Rear defogger switch signal Rear defogger SW ON Input/OFF Input ON input
      Blower fan switch signal Blower fan SW ON Input/OFF Input ON input
      Light switch signal Light SW ON Input/OFF Input ON input
      Wiper switch signal Wiper SW ON Input/OFF Input ON input
      A/C middle pressure switch signal A/C middle pressure SW ON Input/OFF Input ON input
      Air conditioner compressor relay signal Compressor relay ON output/OFF output ON output
      Drain valve signal Vent. Solenoid Valve ON or OFF When drain valve is ON.
      AT retard angle demand signal AT retard angle demand Yes/No Yes
      AT fuel cut signal AT fuel cut Yes/No Yes
      VDC torque down prohibition output Torque down output ON/OFF Prohibition
      VDC torque down demand Torque down demand Yes/No Yes
      AT coordinate permission signal AT coordinate permission signal ON/OFF Permission
      Electronic throttle control motor relay signal ETC motor relay ON/OFF ON
      Stop light switch signal Stop SW ON Input/OFF Input ON input
      SET/COAST switch signal SET/CST SW ON Input/OFF Input ON input
      RESUME/ACCEL switch signal RES/ACC SW ON Input/OFF Input ON input
      Brake switch signal Brake SW ON Input/OFF Input ON input
      Main switch signal Main SW ON Input/OFF Input ON input
      Body integrated unit data reception Body Int. Unit Data Yes/No Yes
      Body integrated unit counter update Body Int. Unit Count Yes/No Yes
      Cruise control cancel switch signal CC Cancel SW ON Input/OFF Input ON input
      Variable valve lift diagnosis oil pressure switch signal 1 Oil Temperature SW1 ON/OFF ON
      Variable valve lift diagnosis oil pressure switch signal 2 Oil Temperature SW2 ON/OFF ON
NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL ".
scientia non olet · About LEMON Manuals