LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Entertainment System >> Rearview Camera System >> Adjustment
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Rearview Camera System: Adjustment

  1. Park vehicle on a level surface with wide space around the vehicle rear side.
  2. Adhere tapes on the floor of the vehicle rear side as shown in the figure, as the datum point of makers.
    NOTE: Use a tape of approx. 30 mm width in bright colors as a criterion.
    Fig 1: Identifying Tapes On Floor Of Vehicle Rear Side
    G05347127
  3. While pressing DEST key and INFO key of navigation system, turn the ignition switch to ON to enter the test mode.
  4. Touch REAR CAMERA MODE in the monitor and go to the maker adjustment mode.
    CAUTION: Do not select other than REAR CAMERA MODE; the navigation system or the navigation monitor may not operate normally.
  5. Touch the monitor to change maker pattern.
    Fig 2: Identifying Maker Pattern
    G05347128
    NOTE: Adjust the marker so that the marker laps over the tape or is placed outside of the tape.
scientia non olet · About LEMON Manuals