September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Using Windshield Knife
- Remove the cowl panel. Refer to REMOVAL
, Cowl Panel.
- Remove the glass molding.
- Tape the body side of the circumference of wind shield glass for protection.
- Apply the sufficient amount of soapy water to the adhesive layer.
- Insert the windshield knife into the adhesive layer.
- While holding the knife edge and windshield glass edge at a right angle, move the windshield knife in parallel to the windshield glass edge along face and edge of windshield glass to cut the adhesive layer.
CAUTION:
- Do not twist windshield knife.
- Cutting of adhesive layer shall be started with wider gap between windshield glass and body.
Courtesy of SUBARU OF AMERICA, INC.
NOTE:
Because the matching pins are bonded to the corners of glass, use piano wire to cut the pin.
Courtesy of SUBARU OF AMERICA, INC.