Fuel Sub Level Sensor: Removal

WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Place "NO FIRE" signs near the working area.
Be careful not to spill fuel on the floor.
During work procedures, if fuel tank is more than 3/4 full, be careful because fuel may spill.

Drain fuel from tank. Refer to DRAINING FUEL , OPERATION, Fuel.
Raise rear seat and turn floor mat up. (Wagon model)
Remove rear seat. (Sedan model)
Remove service hole cover.

Fig 1: Removing Service Hole Cover
Courtesy of SUBARU OF AMERICA, INC.
Disconnect connector from fuel sub level sensor.

Fig 2: Removing Connector From Fuel Sub Level Sensor
Courtesy of SUBARU OF AMERICA, INC.
Disconnect fuel jet pump hose.

Fig 3: Removing Fuel Jet Pump Hose
Courtesy of SUBARU OF AMERICA, INC.
Remove bolts which install fuel sub level sensor on fuel tank.

Fig 4: Identifying Bolts Which Install Fuel Sub Level Sensor On Fuel Tank
Courtesy of SUBARU OF AMERICA, INC.
Remove fuel sub level sensor.