Fuel Level Sensor: Removal

WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Place "NO FIRE" signs near the working area.
Be careful not to spill fuel on the floor.

NOTE: Fuel level sensor is built in fuel pump assembly.

Remove fuel pump assembly. Refer to REMOVAL , Fuel Pump.
Disconnect connector from fuel pump bracket.

Fig 1: Removing Connector From Fuel Pump Bracket
Courtesy of SUBARU OF AMERICA, INC.
Pushing the pawls with a screwdriver, remove fuel level sensor by pulling it downwards.
NOTE: If the retainer pawls are broken during removal, the fuel level sensor must be replaced with a new one.

Fig 2: Removing Fuel Level Sensor
Courtesy of SUBARU OF AMERICA, INC.