LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> ENGINE CONTROLS - Self-Diagnostics >> Diagnostic Tests >> DTC P0182: Fuel Temperature Sensor "A" Circuit Low Input
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

DTC P0182: Fuel Temperature Sensor "A" Circuit Low Input

  1. Turn ignition off. Connect scan tool. Start engine. Observe fuel temperature sensor signal. If displayed value is more than 300°F (150°C), go to next step. If displayed value is less than 300°F (150°C), system has returned to normal. Check for poor connections or intermittent open in wiring. See appropriate wiring diagram in WIRING DIAGRAMS article.
  2. Turn ignition off. Remove fuel pump access cover located in right rear of trunk floor (sedan), or luggage compartment floor (wagon). Disconnect 6-pin fuel pump connector. Turn ignition on. Observe fuel temperature sensor signal. If value is less than -40°F (-40°C), replace fuel temperature sensor. If value is more than -40°F (-40°C), repair short in wiring between fuel pump and ECM connector.
scientia non olet · About LEMON Manuals