LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2010 >> xD Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Control System (Service Information) >> Heated Oxygen Sensor >> Removal >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Heated Oxygen Sensor: Removal: Removal

  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)  . Refer to REMOVAL - Step 1
  2. REMOVE UPPER CONSOLE PANEL  . Refer to REMOVAL - Step 2
  3. REMOVE REAR CONSOLE BOX COVER  . Refer to REMOVAL - Step 3
  4. REMOVE CONSOLE BOX CARPET  . Refer to REMOVAL - Step 4
  5. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY  . Refer to REMOVAL - Step 5
  6. REMOVE FRONT CONSOLE BOX  . Refer to REMOVAL - Step 28
  7. REMOVE HEATED OXYGEN SENSOR 
    1. Disconnect the heated oxygen sensor connector.
      Fig 1: Locating Heated Oxygen Sensor Connector
      GTY165586Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the grommet and pull the sensor connector out of the cabin through the floor panel.
    3. Remove the wire harness clamp bracket.
      Fig 2: Locating Wire Harness Clamp Bracket
      GTY165794Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Using SST, remove heated oxygen sensor.
      • SST: 09224-00010 
      Fig 3: Removing Heated Oxygen Sensor
      GTY160742Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals