LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2008 >> tC Spec, Standard >> Repair and Diagnosis >> Engine Performance >> 2AZ-FE Engine Control System >> Crankshaft Position Sensor >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Crankshaft Position Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE FRONT FENDER APRON SEAL RH  (See REMOVAL )
  3. REMOVE FAN AND GENERATOR V BELT  (See REMOVAL )
  4. REMOVE GENERATOR ASSEMBLY  (See REMOVAL )
  5. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
      2. Fig 1: Identifying Sensor Connector
      G05183813Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the connector clamp.
    3. Remove the wire harness from the wire harness clamp bracket.
    4. Remove the wire harness clamp.
    5. Remove the bolt and sensor.
scientia non olet · About LEMON Manuals