LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 601 (Disc Brake System) >> Repair Instructions >> Rear Brake Caliper Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the caliper slide boots for cuts, tears or deterioration. If damaged, replace the slides and the boots. Refer to Disc Brake Hardware Replacement - Rear .
    2. Fig 1: View Of Caliper Assembly & Retainers
    GM63989Courtesy of GENERAL MOTORS CORP.
  2. Install the brake caliper to the caliper mounting bracket.
    3. NOTE: Refer to Fastener Notice .
  3. Install the brake caliper guide pin bolts.

    Tighten:  Tighten the brake caliper guide pin bolts to 31 N.m (23 lb ft).

    4. Fig 2: View Of Brake Caliper & Brake Hose
    GM63948Courtesy of GENERAL MOTORS CORP.
  4. Remove the plug from the brake caliper opening and the brake hose.
    5. IMPORTANT: Install NEW copper brake hose gaskets.
  5. Assemble the NEW copper brake hose gaskets and the brake caliper inlet fitting bolt to the brake hose.
  6. Install the brake hose and the brake caliper inlet fitting bolt to the brake caliper.

    Tighten:  Tighten the brake caliper inlet fitting bolt to 45 N.m (33 lb ft).

  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals