Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
- Install the HVAC control module to the I/P trim plate.
- Install the HVAC control module retaining screws.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
- Connect the electrical connectors to the HVAC control module.
- Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
- Connect the battery. Refer to Battery Negative Cable Disconnection and Connection .
- Start and allow the engine to run for at least one minute.
- Refer to Control Module References for programming and setup information.
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Do not adjust any controls on the HVAC control module while the HVAC control module is self-calibrating. If interrupted, improper HVAC performance will result.
The engine must be running for proper calibration to occur.
The engine must be running for proper calibration to occur.