Headlamp Replacement

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Headlamp - High Intensity Discharge (HID)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .
1	Headlamp Assembly Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tip: Tighten the fasteners in sequence as shown. Tighten: 6 N.m (53 lb in)
2	Headlamp Assembly Nut Tighten: 6 N.m (53 lb in)
3	Headlamp Assembly Tip: Pull outward on the housing in order to disconnect the electrical connection at the lower rear edge of the lamp.
4	Electrical Harness Connector Tip: Disconnect the electrical connector from the headlamp assembly.