LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Vue Base, 3.5 4, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L (L66) Introduction >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Installation Procedure

  1. Remove the shop towel from the throttle body opening.
  2. Install a new throttle body gasket.
    3. NOTE: Use care when tightening the throttle body bolts. Manifold damage will result if over torqued.
    Fig 1: Removing/Installing The Throttle Body
    GM1226494Courtesy of GENERAL MOTORS CORP.
  3. Install the throttle body assembly and fasteners.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the throttle body fasteners.

    Tighten:  Tighten the fasteners to 22 N.m (16 lb. in.).

  5. Attach the coolant hoses (4) to the throttle body assembly and unclamp.
    Fig 2: Removing/Installing Coolant Hoses At Throttle Body (4)
    GM1233528Courtesy of GENERAL MOTORS CORP.
  6. Install the wiring harness bracket bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb. in.).

  7. Connect the MAP sensor connectors.
  8. Connect throttle body electrical connector.
    Fig 3: Connecting MAP Sensor Connector & Throttle Control Connector At Throttle Body
    GM1226493Courtesy of GENERAL MOTORS CORP.
  9. Install the outlet resonator/duct assembly into position. Refer to Air Cleaner Resonator Outlet Duct Replacement .
    Fig 4: View Of Outlet Resonator/Duct Assembly
    GM1226468Courtesy of GENERAL MOTORS CORP.
  10. If the throttle body assembly has been replaced, perform the idle learn procedure. Refer to Idle Learn Procedure .
scientia non olet · About LEMON Manuals