LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Automatic Transaxle - Introduction & Repair Instructions) >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
    2. Fig 1: Removing & Installing Shifter Cable From Control Assembly
    GM944208Courtesy of GENERAL MOTORS CORP.
  2. Using a J 36346  , disconnect the shifter cable from the control assembly pin. See Special Tools .
  3. Remove the shifter cable from the control assembly.
    4. Fig 2: Park Lock Cable Assembly & Pin On Control Assembly
    GM944348Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the park lock cable assembly from the pin on the control assembly.
    5. Fig 3: Removing & Installing Indicator Bulb By Rotating Bulb A Quarter Turn And Pulling Out
    GM945404Courtesy of GENERAL MOTORS CORP.
  5. Remove the indicator bulb by rotating the bulb a quarter turn and pulling out.
    6. Fig 4: Control Assembly Electrical Connectors
    GM944353Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the control assembly electrical connectors.
    7. Fig 5: Removing & Installing Nuts From Control Assembly
    GM944361Courtesy of GENERAL MOTORS CORP.
  7. Remove the nuts from the control assembly.
  8. Remove the control assembly and replace if necessary.
scientia non olet · About LEMON Manuals