Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Object Alarm Detection Module

Courtesy of GENERAL MOTORS CORP.

Install the rear object alarm detection module.
Install the electrical connector to the module.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts that secure the rear object alarm detection module.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Secure the top of the quarter trim over the bolts.

Fig 2: Identifying Rear Liftgate Sill

Courtesy of GENERAL MOTORS CORP.

Install the cargo tie-down loops from the rear quarter trim.
Install the rear liftgate sill.
Install the storage compartment. Refer to Storage Compartment Replacement - Rear (Rendezvous) in Interior Trim.

Fig 3: View Of Upper Trim From Second & Third Row Pillars

Courtesy of GENERAL MOTORS CORP.

Install the upper trim from the second and third row pillars.

Fig 4: Locating Guide Loop Bolt

Courtesy of GENERAL MOTORS CORP.

Install the guide loop bolts from the second and from the third row seat belts.

Fig 5: Identifying Guide Loop Covers From LH Rear Seat Belt

Courtesy of GENERAL MOTORS CORP.

Close the guide loop covers to the left rear seat belt.

Fig 6: Aligning Second Row Seats Forward

Courtesy of GENERAL MOTORS CORP.

Return the second and the third row seats to their upright positions.