LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> L300 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Shift Control Cable Replacement - Floor Shift >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    Fig 1: Removing & Installing Shift Control Cable From Control Assembly
    GM893834Courtesy of GENERAL MOTORS CORP.
  1. Pull up on control boot until indicator bezel disengages from console.
  2. Remove the console. Refer to Console Replacement in Instrument Panel, Gages and Console.
  3. Using a screwdriver, disconnect the control cable from the control assembly.
  4. Disconnect the electrical connector from the indicator bezel.
  5. Remove the control cable retaining clip.
  6. Press the tabs on the control cable and remove the cable from the control assembly.
    7. Fig 2: Removing & Installing Shift Control Cable From Transaxle Range Switch Lever
    GM893827Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the control cable from the transaxle range switch lever.
  8. Remove the control cable retaining clip.
  9. Press the 2 tabs on the control cable and remove the cable from the control cable bracket.
    10. Fig 3: Removing & Installing Shift Control Cable From Vehicle
    GM893234Courtesy of GENERAL MOTORS CORP.
  10. Remove the control cable grommet from the dash panel.
  11. Remove the control cable from the vehicle.
scientia non olet · About LEMON Manuals