LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Antilock Brake System And TCS) >> Repair Instructions >> Brake Pressure Modulator Valve Bracket Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line, 2007 Saturn Ion 3, and 2007 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of BPMV Bracket
    GM890992Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV assembly bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake pressure modulator assembly bracket mounting nut and mounting bolts.

    Tighten: 

    • Tighten the nut to 25 N.m (18 lb ft).
    • Tighten the bolts to 25 N.m (18 lb ft).

    3. Fig 2: ABS Modulator Bracket Forward Lamp Harness Retainer
    GM891778Courtesy of GENERAL MOTORS CORP.
  3. Secure the forward lamp wiring harness retainer to the BPMV bracket.
    4. Fig 3: Locating Insulator Nuts
    GM890990Courtesy of GENERAL MOTORS CORP.
  4. Install the brake modulator assembly to the bracket.
  5. Tighten the 2 brake pressure modulator assembly insulator nuts (1).

    Tighten:  Tighten the nuts to 8 N.m (71 lb in).

  6. Secure the EBCM wiring harness retainer to the BPMV bracket.
scientia non olet · About LEMON Manuals