LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2001 >> LW200 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0442: EVAP System - Small Leak Detected >> Diagnostic Procedures
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Diagnostic Procedures

  1. Turn ignition on, engine off. Remove fuel cap. Using scan tool, monitor FUEL TANK PRESS. SENSOR. If voltage is 2.35-2.85 volts, go to step  3. If voltage is not 2.35-2.85 volts, go to next step.
  2. If voltage is less than 0.10 volt, see DTC P0452: EVAP FUEL TANK PRESSURE SENSOR CIRCUIT - LOW VOLTAGE . If voltage is 0.10-2.35 volts or 2.85-4.90 volts, replace fuel tank pressure sensor. If voltage is more than 4.90 volts, see DTC P0453: EVAP FUEL TANK PRESSURE SENSOR CIRCUIT - HIGH VOLTAGE .
  3. Install fuel cap. Using scan tool, perform EVAP SYSTEM SEAL special functions. Connect EVAP Pressure/Purge Cart (J 41413) to EVAP service port. Pressurize system to 8 in. H2O, then switch to HOLD position. Use ultrasonic leak detector to locate small leaks. After repairs, retest system.