LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2000 >> LW1 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Controls - Self-Diagnostics) >> Self-Diagnostic System >> Hard Or Intermittent Trouble Code Determination
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Hard Or Intermittent Trouble Code Determination

WARNING: This page is about a different car, the 2000 Saturn LW2 and 2000 Saturn LS2. However, it is still accessible from the selected car via links, so may be relevant.

During any diagnostic procedure, determine if DTC(s) are hard failure DTCs or intermittent failure DTCs. Diagnostic procedures will not always help analyze intermittent DTCs. To determine hard DTCs and intermittent DTCs:

  1. Enter diagnostic mode. Read and record all stored DTCs. Exit diagnostic mode and clear DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES .
  2. Apply parking brake and place transmission in Neutral or Park. Block drive wheels and start engine. MIL should turn off. Allow engine to reach normal operating temperature and continue to run for 2 minutes and note MIL.
  3. If MIL illuminates, enter diagnostic mode. Read and record DTCs. This will reveal hard failure DTCs. Oxygen sensor-related DTCs may require a road test to reset hard failures after DTCs were cleared.
  4. If MIL does not illuminate, all stored DTCs were intermittent failures.

NOTE: DTCs will be recorded at various operating times. Some DTCs require operation of that sensor or switch for 5 seconds; others require operation for 5 minutes or more at normal operating temperature, vehicle speed and load. Therefore, some DTCs may not set in a service bay operational mode and may require road testing vehicle in order to duplicate conditions under which DTC will set.
scientia non olet · About LEMON Manuals