| A/C Indicator |
The HVAC control module illuminates the A/C indicator when commanded from the scan tool. |
| A/C Switch |
This control function simulates the state of the A/C switch. |
| Air Recirculation Door Motor Direction |
The HVAC control module commands the air recirculation actuator from venting to recirculation and back again. |
| Air Recirculation LED Command |
The HVAC control module illuminates the Air Recirculation indicator when commanded from the scan tool. |
| Air Recirculation Mode Switch |
When On is selected, the HVAC control module commands the air recirculation door from outside air to recirculation. When Off is selected, the HVAC control module commands the air recirculation door from recirculation to outside air. |
| Auto HVAC Indicator |
The HVAC control module illuminates the Auto indicator when commanded from the scan tool. |
| Auxiliary Heater Request |
When On is selected, the HVAC control module sends a request signal to the auxiliary heater. |
| Auxiliary Mode Door Position |
The HVAC control module commands the rear mode actuator from defrost to floor and back again. |
| Auxiliary Mode Switch Position |
This control function simulates the state of the rear mode switch. |
| Blower Speed Indicator 1-6 |
The HVAC control module illuminates the appropriate blower speed indicator when commanded from the scan tool. |
| Blower Motor Speed Command |
The HVAC control module commands the blower motor speed from 0 to 100% and back again. |
| Blower Motor Switch |
This control function simulates the state of the blower motor switch. |
| Enhanced Defrost Indicator |
The HVAC control module illuminates the enhanced defrost indicator when commanded from the scan tool. |
| HVAC Actuators |
The HVAC control module executes the Motor Learn Routine when commanded from the scan tool. |
| HVAC Afterblow Configuration |
This control function disables and enables the afterblow configuration. |
| Left Temperature Door Motor Direction |
When Increase is selected, the left temperature door position increases stepwise. When Decrease is selected, the left temperature door position decreases stepwise. |
| Left Temperature Door Position |
The HVAC control module commands the left temperature actuator from cold to hot and back again. |
| Mode Door Motor Command |
The HVAC control module commands the mode actuator stepwise from defrost to floor and back again. |
| Mode Door Position |
When Floor is selected, the HVAC control module commands the mode actuator to the floor position. When Defrost is selected, the HVAC control module commands the actuator to the defrost position. |
| Switch |
This control function simulates the state of the MODE switch. |
| MULTI-ZONE Switch |
This control function simulates the state of the ZONE switch. |
| Rear Defog |
The HVAC control module commands the rear defogger On and Off. |
| Rear Defogger Indicator |
The HVAC control module commands the rear defogger indicator On and Off. |
| Rear Mode Door Motor Position |
The HVAC control module commands the rear mode actuator stepwise from floor to defrost and back again. |
| Rear Temperature Door Motor Direction |
The HVAC control module commands the rear temperature actuator stepwise from cold to hot and back again. |
| Recirculation Door |
The HVAC control module commands the recirculation actuator stepwise from outside air to recirculation and back again. |
| Right Temperature Door Position |
When Increase is selected, the right temperature door position increases stepwise. When Decrease is selected, the right temperature door position decreases stepwise. |