LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Liftgate Control Module Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Disconnecting/Connecting Liftgate Module Electrical Connectors
    GM749979Courtesy of GENERAL MOTORS CORP.
  1. Install the module to the liftgate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts that retain the module to the liftgate.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Connect the electrical connectors (3) as necessary.
  4. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate .
  5. Program the liftgate control module. Refer to Control Module References in Computer/Integrating Systems.
scientia non olet · About LEMON Manuals