LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Glow Plug Control Module Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Glow Plug Control Module Bracket
    GM1862083Courtesy of GENERAL MOTORS CORP.
  1. Position the glow plug control module bracket (4), if required.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the glow plug control module bracket bolts (3), if required. Tighten the bolts to 10 N.m (89 lb in).
  3. Position the glow plug control module (2).
  4. Install the glow plug control module bolts (1) and tighten to 10 N.m (89 lb in).
    5. Fig 2: Identifying Positive Battery Cable
    GM1862082Courtesy of GENERAL MOTORS CORP.
  5. Connect the positive battery cable (1) to the glow plug control module.
    6. Fig 3: View Of Engine Wiring Harness Electrical Connector
    GM1862080Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine wiring harness electrical connector (1) to the glow plug control module.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  8. If a NEW glow plug control module was installed, program the module. Refer to Control Module References .
  9. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals