LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Fuel Temperature Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying FRT Sensor
    GM1732315Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the FRT sensor electrical connector and tighten to 22 N.m (16 lb ft).
    2. Fig 2: Identifying intake air temperature sensor
    GM1732300Courtesy of GENERAL MOTORS CORP.
  2. Connect the FRT sensor electrical connector.
  3. Install the fuel line retainer center of engine.
  4. Install the rear fuel line retainer.
  5. Install the charged air inlet tube. Refer to Charged Air Cooler Hoses/Pipes Replacement (Inlet) or Charged Air Cooler Hoses/Pipes Replacement (Outlet)
  6. Install the glow plug module and bracket. Refer to Glow Plug Control Module Replacement .
  7. Prime the fuel system. Refer to Fuel System Priming .
  8. Once engine starts, inspect for leaks.
  9. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals