LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Seat Belt System) >> Repair Instructions >> Child Restraint Tether Anchor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G8. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Child Seat Anchor Assembly
    GM2043543Courtesy of GENERAL MOTORS CORP.
  1. Install the child seat anchor assembly to the rear window shelf.
    2. Fig 2: Identifying Child Seat Anchor Assembly To Body Retaining Bolt
    GM2043542Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice .
    IMPORTANT: Ensure child restraint assembly is installed as per illustration, failure to adhere to this installation will result in incorrect operation of the child restraint assembly.
    IMPORTANT: Ensure that the anchor fitting is parallel to the vehicle centerline.
  2. Install the child seat anchor assembly to body retaining bolt (2).

    Tighten:  Tighten the bolt to 20 N.m (22 lb ft).

  3. Close the child seat anchor assembly cap (1).
scientia non olet · About LEMON Manuals