LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System & Fuel System - 3.5L - Introduction) >> Repair Instructions >> Ignition Control Module Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing 4 Screws Securing Ignition Coil And Module Assembly To Bracket
    GM1238999Courtesy of GENERAL MOTORS CORP.
  1. Note the position of the spark plug wires for the installation and disconnect the spark plug wires from the ignition coil and module assembly.
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  3. Remove the 4 screws securing the ignition coil and module assembly to the bracket.
  4. Remove the ignition coil and module assembly.
scientia non olet · About LEMON Manuals